there are 3 ways to clone a set of TMP sensors using Autel TS601 scanner and a MX-sensor
Method 1:
using TS601 to activate the broken OE sensor
directly to retrieve the sensor id
then program to the MX-sensor
Method 2:
it’s used when the original sensor is not transmitting any more
in this case, connect the MaxiTPMSTS601 scan tool to the vehicle by the TS601 OBDII cable
and retrieve the sensor id from the car system
unplug the TS601 from the car when learning is successful
insert the MX-sensor and program the copied id to the sensor to finish coding
Method 3:
it’s to manually input the original sensor id to Autel TS601
then program it to the MX-sensor
since the new sensors are programmed with the same original sensor id, install it in the same position on the wheel
no TPMS relearn procedure is needed after replacement